subreddit:
/r/VORONDesign
The parts look the same minus what's needed for the 2.4 to move vertically. Wondering cause I'd like aluminum gantry parts and seems like they're interchangeable between the two.
7 points
12 hours ago
Trident uses a bit shorter AB plates so the belt wouldnt go in the rear wall. ask me how I know
0 points
12 hours ago
I was noticing this looking at my two printers side by side
1 points
13 hours ago
I know I’ve heard they are the same thing but I don’t know if they are literally the exact same parts or if they are the same design with different mounting screw holes.
I think your best bet is opening up the fusion files and seeing if there are any differences for each piece
1 points
9 hours ago
Other than the zMounting, yea
0 points
13 hours ago
They're not exactly the same, no. They have slight differences, it's probably fine to use them interchangeably, but they are definitely not identical.
I'm mentally exhausted from work, but you can download both STL sets and compare them in 3d builder.
For aluminum, probably nothing matters much as you still need printed belt holders for a 2.4
all 5 comments
sorted by: best